ProForm 831.28622.0 user manual Maintenance and Troubleshooting, Battery Replacement

Page 12

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately.

To clean the elliptical exerciser, use a damp cloth and a small amount of mild dish soap. Important: Keep liquids away from the console and keep the con- sole out of direct sunlight. During storage, remove the batteries from the console.

BATTERY REPLACEMENT

If the console display becomes dim, the batteries should be replaced. See assembly step 3 on page 6 for replacement instructions.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, you must first remove the Right Pedal Leg (12), the right Pedal Disc (15), and the Side Shields (3, 4). See step 8 on page 8 and remove the Right Pedal Leg.

 

15

64

3

4

 

 

 

12

 

70

52

 

 

 

41

 

 

 

64

 

 

51

 

41

52

 

70

 

64

 

Next, remove the four Screws (51, 70) from the right Pedal Disc (15), and slide the Pedal Disc off. Remove all Screws (52, 64) from the Right Side Shield (4) and the two Bolts (41) from beneath the Pedal Disc, and remove the Right Side Shield (4). Remove all Screws

(52)from the Left Side Shield (3), and move the Left Side Shield.

Next, see the drawing below and locate the Reed Switch (53). Loosen, but do not remove, the indicated M4 x 16mm Self-tapping Screw (52). Slide the Reed Switch slightly toward or away from the Magnet (58) on the flywheel. Retighten the Screw. Turn the left Pedal Disc (15) for a moment. Repeat until the console dis- plays correct feedback. When the Reed Switch is cor- rectly adjusted, reattach the Side Shields (3, 4), the right Pedal Disc (15), and the Right Pedal Leg (12).

58

53

15

52

HOW TO ADJUST THE DRIVE BELT

If you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest level, the Drive Belt (19) may need to be adjusted. To adjust the Drive Belt, you must first remove both side shields. See HOW TO ADJUST THE REED SWITCH at the left and remove the side shields.

Next, loosen

 

 

the M8 x

 

 

22mm Flat

 

 

Head Screw

 

 

(65) and turn

 

 

the M10 x

 

 

60mm Button

65

 

Bolt (62) until

 

 

 

the Drive Belt

 

 

(19) is tight.

62

 

When the

19

 

Drive Belt is

 

 

tight, tighten

 

 

the Flat Head Screw. Then, reattach the side shields.

12

Image 12
Contents Assembly Operation Maintenance Part List and Drawing Model No .28622.0 Serial NoTable of Contents Important Precautions Before YOU Begin FrontBack Left SideAssembly Page Wires do not get Button Bolts yetMake sure PinchedPage HOW to USE the Elliptical Exerciser HOW to Exercise on the Elliptical ExerciserHOW to USE the Console Turn on the consoleChangedesired. the resistance of the pedals as Follow your progress with the displaysTurn on the fan if desired Will automatically turn offMaintenance and Troubleshooting Battery ReplacementHOW to Adjust the Reed Switch HOW to Adjust the Drive BeltConditioning Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No Qty DescriptionR1107A DAY Full Warranty Get it fixed, at your home or ours