First, loop leash through slot on side of pedometer
Next, clasp clothing
Or, loop a belt or belt loop
16
Or, loop a badge holder, then put into pocket (Badge holder not included)
VIEWING YOUR RESULTS
Once you put on your pedometer with the cover closed, it will automatically begin to record your steps and activity time. Repeatedly press the MODE button to cycle through the pedometer modes:
STEPS gTIME g STEPS
Activity time is counted automatically whenever steps are being counted.
• TIME is time spent in step activity.
Note: For extra accuracy, the default Step Filter Setting is 1. See page 21 to learn more.
17
GOAL TRACKING
As discussed in beginning of instructions, this unit keeps track of your progress towards the Step andTime goals you set. Progress is shown as a series of small bars appearing on the bottom of the display, with each bar representing 5% of the total. For example, if you set your step goal to 4,000 steps, and you’ve walked 2,000 steps so far, the goal indicator in STEP mode will show as 50% complete. Progress towards each goal is shown on the corresponding screen
–for example, when viewingTIME, you will see both the time traveled in hours and minutes, and also the progress towards your time goal on the bottom of the display.
18
RESETTING YOUR PEDOMETER
Most people prefer to reset counts daily. To reset your counts: From STEP or TIME mode, press and hold the yellow RESET button for at least 2 seconds. You’ll see the values all go back to zero.
OTHER SETTINGS
The Step Filter setting is accessed through a special “deep set” mode.
To enter this mode, press and hold the S1 (SET) button for 4 seconds.The screen will display a flashing single digit.
19
CHANGING STEP FILTER SETTING
While the JW200 PedometerEngine™ Step Sensor is extremely accurate, some people like to have the ability to filter out false steps. Therefore, the unit has a variable setting step filter, to allow
You can set the value to any value from 0 – 5 steps. For example, if the filter is set to “3”, the unit will wait to start counting steps until more than three steps have been taken in less than five seconds.
Press S3+ (MODE) or S3– (RESET) to change the step filter setting. Press and hold S4 (SET) for 2 seconds to exit Deep Set Mode.
20
Note: The unit will save any changes and exit set mode after 30 seconds unattended.
Can be set |
|
|
|
|
| ||
from | STEP | TIME |
|
| SET | ||
steps |
|
|
|
|
|
| MY |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| GOAL |
0 | 20 | 40 | 60 | 80 | 100% | ||
120XLG
JW200 | S3- | S1,S2,S4 | S3+ |
|
Set Step Filter set point
21
REPLACING THE BATTERY AND MASTER RESET
When the display starts to dim or goes blank, it is time to replace the battery.
If the display is not uniformly dim or blank, and appears to display “erroneous data”, do a Master Reset by pressing all 3 buttons simultaneously for 3 seconds and then release.
The display should go blank, then turn all segments on, then display 0 steps in Step Mode.
Note: All the settings will return to their default setting values. If you need to change the battery, the settings will also revert to default settings.
22
To replace the battery:
1. Insert a coin into the slot on the bottom of the case, and twist to loosen the faceplate. Remove faceplate and set aside.
2. Locate the battery holder as seen |
| |
on sketch. Pull out the old battery, | Battery | |
and push a new | ||
| ||
with positive terminal (+) facing up. |
|
3.Snap faceplate back into place, hooking the bottom two tabs first, then closing by pressing together at the top two tabs.
23