MEMORIES
This pedometer has memories to keep track of your activity data for today, this week, and last week. The unit stores your steps, distance, calories, and activity time data for each of these time periods. It can also display your daily averages of these measures for the previous week.
To view today’s data, press the aqua DAY.CUM button until a bar appears underneath the DAY indicator in top right hand corner of display. Now, repeatedly press the yellow MODE button to view steps, distance, calorie, and activity time values for the day.
To view this week’s total data, press the aqua DAY.CUM button until a bar appears underneath the CUM indicator in top right hand corner of display. Now, repeatedly press the yellow MODE button to view steps, distance, calorie, and activity time values accumulated so far this week.
To view the previous week’s data, you must start from the steps, distance, calories, or activity timer mode. Press the cream MEMORY
of display will change to say “Avg” (for AVERAGE). To exit back to today’s or this week’s data, press the cream MEMORY button one more time.
AUTO MOVEMENT SENSOR
1.To filter out random movements, the unit remains in standby mode until 5 continuous steps are registered. Only then are the 5 steps calculated in, and an Active indicator “▲” appears on the upper left of display.
2.When regular walk/run movement stops, after 2 seconds the timer pauses and the unit switches to standby status (Active indicator “▲” disappears).
RESETTING YOUR PEDOMETER
Most people prefer to reset step counts daily.To reset: While displaying Day’s STEPs, DISTANCE, or ACTIVITYTIME, press and hold yellow RESET button for at least two seconds to reset all of these to zero. When displayingTotal STEPs, press aqua RESET button for two seconds to reset all counts, includingTotal STEPS, to zero.
REPLACING THE BATTERY
When the display starts to dim or goes blank, it is time to replace the battery.Your pedometer uses oneType LR43 (L1142) 1.5 volt alkaline battery.To replace:
1.Insert a coin into the slot on the bottom of the case, and twist counterclockwise to loosen the case front. Lift case front away.
2.Using a pen or other thin object, push battery sideways out of its holder. Replace it with a new battery.The battery’s positive (+) terminal should be FACE UP while you put it into the pedometer.
3.Align case front over the pedometer and press gently to snap cover back into place, starting with top.
REGISTER NOW Please return | Email (preferred) |
|
| |
| ||||
your AE1640M4 Registration to | User |
| ||
the Repair Center address in the |
| |||
|
|
|
| |
warranty, and we will let you know |
|
|
|
|
|
|
|
| |
about future products. |
|
|
|
|
|
|
|
|
|
NO-PROOF-OF-PURCHASE LIMITED WARRANTY
See label inside the lid of your pedometer