Seiko 5d88 manual Improper Function, How to reset the built-in IC, Automatic Hand Alignment

Page 11

IMPROPER FUNCTION

English

When the watch stops operating even though it displays the remainder of the

 

 

power reserve, follow the instructions below to reset the built-in IC.

 

■ How to reset the built-in IC

 

 

15

 

10

20

 

5

5

 

 

2

 

 

29

 

0

1

 

2

1.Pull out the crown to the second click.

2.Press the button for 2 seconds or more using a sharp-pointed tool (e.g. ball point pen).

3.Push the crown back into the normal position.

The indicator hand will point at the 0 position, and the watch resumes its normal

operation.

If the indicator hand points at under the 0 position, sufficiently charge the watch. Refer to “How to charge and start the watch”.

By conducting this operation, the indicator hand moves to the 0 position even though it displayed that there was remaining power reserve; however, this is not a malfunction.

If the watch does not resume normal operation even after resetting the built-in IC, consult the retailer from whom the watch was purchased.

4.Turn the crown to charge the watch at least until the indicator hand points at the second marking above "0"(approximately 6 hours of power reserve). And then set the time, date, day of the week, and moon phase.

AUTOMATIC HAND ALIGNMENT

The position of the indicator hand may move out of alignment in rare cases. The watch automatically corrects the position of the indicator hand once every 24 hours. While correcting the hand position, the indicator hand moves abnormally, however, this is not a malfunction. After automatic hand alignment is performed, the indicator hand will return to display power reserve amount.

<About the movement of the indicator hand during automatic hand alignment>

When automatic hand alignment starts, the indicator hand moves to the area under the 0 position and vibrates, and then points at the 0 position. After automatic hand alignment is completed, the indicator hand returns to display power reserve amount.

English

20

21

Image 11
Contents Cal D88 Contents Display and Button Operation FeaturesTurn the crown clockwise repeatedly to charge the watch HOW to Charge and Start the WatchCrown with Driving Wheel OnesEnglish How to read the direct drive indicatorCan be displayed Power reserve indicatorReal-time power indicator Maximum 6 hours of generated power can be displayedTotal amount of power reserve after approximately 4 seconds How to read the direct drive indicator while chargingIndicator hand starts moving Continue to turn the crown. The indicator hand moves upwardDisplay Push the crown back in to the normal position TIME/CALENDAR SettingHow to set the date and day EnglishEnglish How to set the moon phaseAutomatic Hand Alignment How to reset the built-in ICImproper Function Storage device Power Source Rechargeable batterySpecifications Batteries for watches