Timex 567-095006 NA manual Setting Operation

Page 7

SET	START / SPLIT
SET
	INDIGLO¨
MODE	STOP / RESET

Setting Operation

When setting Time of Day, Alarms or the Countdown Timer and so on, the button functions change from what is print- ed on the case.

NOTE: These setting functions are the same in any mode where you can set a value.

1.Press and hold the SET button. While you are holding the button, “HOLD ADJUST” will appear on the display.

2.After a couple of seconds, the “HOLD” message will disappear followed by a flashing value.

3.Change the flashing value by pressing either START/SPLIT (to increase) or STOP/RESET (to decrease). Press and hold the button to increase/decrease the value quickly.

4.When the flashing value is set as intended, press MODE to advance to the next value.

10

11

Image 7

Contents 195 567-095006 NA Page Introduction Watch Features Watch Modes Button Functions Introduction Watch Features Time of DayAltimeter Thermometer Count Down TimerAlarm BarometerButton Functions INDIGLO¨ Night-Light Watch ModesSetting Operation Watch Display Symbols Weather Forecasting What is calibration?Temperature Accuracy Setting Time of Day Time Time of Day ModeViewing the secondary time zone Using the Dual Time Zone featureViewing Temperature and Air Pressure Data Switching time zonesBaro Barometer Mode Selecting Pressure and Temperature Units Viewing Temperature and Pressure DataCalibrating the Barometer What is ÒSea Level PressureÓ? Using the Altimeter Alti Altimeter ModeAltimeter Performance Selecting Altitude UnitsCalibrating the Altimeter and Clearing High and ACC Using the Chronograph Chro Ð Chronograph ModeTerminology Changing the Display Format Lap/Split TimingIf you have taken at least one lap Setting the Countdown Timer Timer Countdown Timer ModeSetting an Alarm Alarm Alarm ModeSelecting and Arming/Disarming Alarms Timex International Warranty Trademark and Warranty Information