STEP 3 (SEE DIAGRAM 3)
A.) Attach the Leg Developer (#38) onto the bracket on the Front Stabilizer (#42). Secure it with an Allen Socket Axle (#44) and Allen Socket Screw (#45).
B.) Insert two Foam Roll Tubes (#39) halfway through the hole on the Leg Developer. Push
four Foam Rolls (#37) onto the Tube from both ends. Plug four Ø 1” Foam Roll End Caps (#36) onto each end of the Tubes.
C.) Clip a Spring Clip (#34) onto the post on the Leg Developer.
D.) Attach the Arm Curl Handle Support (#54) to the Leg Developer. Secure it with a Short Lock Pin (#8). Remove Pin when using the Leg Developer.
DIAGRAM 3
6