JVC UX-V20R/UX-V10 manual Using the Cassette Deck Recording, Standard Recording

Page 20
Adhesive tape
Type II detection slot

English

Using the Cassette Deck (Recording)

 

SLEEP

DISPLAY

FM

AUTO

 

MODE

PRESET

 

AUX

TAPE

FM/AM

CD

TAPE @ #

 

 

CD

 

 

 

 

REPEAT

PTY/EON

UP

DISPLAY

 

MODE

 

PROGRAM

 

SET

 

 

RANDOM

 

DOWN

 

 

AHB

 

 

 

 

PRO

BASS

TREBLE

CANCEL

VOLUME

REMOTE CONTROL RM-SUXV20R

 

 

STANDBY

 

 

 

 

 

 

 

 

AHB

 

 

AUX

 

 

PRO

 

 

 

 

 

VOLUME

 

 

REC

 

 

TIMER

 

REC

REV

 

 

 

 

MODE

 

 

CLOCK

CD #·8

REV. MODE

 

 

 

CD

 

TAPE

FM/AM

CD

OPEN/CLOSE

7

TAPE @ #

CD #·8

DOWN

MULTI CONTROL

UP

 

 

PHONES

 

 

 

7

Tape Direction indicator

REC indicator REC

When the System is in use, the display shows other items as well.

For simplicity, only the items described in this section are shown here.

Reverse Mode indicator

Recording onto a tape from any of the sound sources is simple. Just

Standard Recording

place a tape in the Cassette Deck, have the source ready, make one

or two settings, and you’re ready to record. For each source the

You can record any sound source to tape as follows:

procedure is a little bit different so we explain each separately. But

 

 

first, here are a few things to make your recordings better.

 

Insert a blank or erasable tape into the

1

 

 

Cassette Deck.

Things to know before you start recording –––––––––––––––––––––––––––––

It may be unlawful to record or play back copyrighted material without the consent of the copyright owner.

When you want to record onto both sides of a tape, you can set Reverse mode to do so. Recording automatically stops after recording in the 2direction. Therefore, make sure that the tape direction is 3 when recording with Reverse mode on.

The recording level, which is the volume at which the new tape is being made, is automatically set correctly, so it is not affected by the VOLUME control on the System. Nor is it affected by adjusting the sound effects. Thus, during recording you can adjust the sound you are actually listening to without affecting the recording level.

Two small tabs on the back of the cassette tape, one for side A and one for side B, can be removed to prevent accidental erasure or recording.

To record on a cassette with the tabs removed, you must cover the holes with adhesive tape first. However, when a type II tape is used, only cover part of the hole as shown, since the other part of the hole (Type II detection slot) is used to detect the tape type.

Type I and Type II tapes can be used for recording.

Note: At the start and end of cassette tapes, there is leader tape which cannot be recorded onto. Thus, when recording CDs or radio broadcasts, wind on the leader tape first to ensure that the recording will be made without any music part lost.

CAUTION:

If a recording you make has excessive noise or static, the Unit may have been too close to a TV which was on during the recording. Either turn off the TV or increase the distance between the TV and the System.

2If you want to record on both sides of a tape, press the REV. MODE button on the Unit until the indicator is lit.

When using Reverse mode, insert the tape so that it will be recorded in the forward 3direction.

3Check the recording direction for the tape.

Make sure that the Tape Direction indicator is the same as that for the tape in the Cassette Deck. If the directions are different, press the TAPE @#button to correct the tape direction and then press the 7button to stop the tape.

4Prepare the source by, for example, tuning in a radio station or turning on

connected auxiliary equipment.

Note: For CD recording, refer to “CD Direct Recording” on page 17.

5Press the REC button on the Unit.

The REC indicator lights up and the System begins recording.

Notes for using Reverse mode for recording

When recording in Reverse mode, the System automatically stops when it reaches the end of the reverse 2direction. To record on both sides of a tape, make sure that the recording direction for the tape inserted is forwards 3, and that the Tape Direction indicator is also forwards 3, before you start recording.

To stop at any time during the recording process

Press the 7 button.

16

Image 20
Contents Micro Component System UX-V10Achtung Voorzichtig Goede ventilatie vereist Vorsicht Ausreichende BelüftungPrecaucion ventilación correcta Attenzione Per una corretta ventilazioneClass Laser Product Table of Contents Accessories How to Put Batteries in the Remote ControlUsing the Remote Control Getting StartedConnecting the FM Antenna Connecting the AM MW/LW AntennaUsing the supplied Wire Antenna Using the coaxial type connector not suppliedConnecting the Speakers Connecting External EquipmentConnecting the AC Power Cord On the Unit On the Remote ControlTurning the Power On and Off Adjusting the VolumeCommon Operations Turning the System onAdjusting the bass level Adjusting the treble levelReinforcing the Bass Sound AHB PRO Controlling the Tone Bass/ TrebleUsing the Tuner Tuning In a StationPresetting Stations Presetting stations manuallyChanging the FM Reception Mode Presetting stations automaticallyReceiving FM Stations with Press the SET button within 5 secondsSearching for a program by PTY codes Switching to a program type of your choice temporarily News NewsUnloading a CD Using the CD PlayerInserting a CD Basics of Using the CD Player Normal Play Programing the Playing Order of the TracksPress the Random button on the Remote Control Press the Repeat button on the Remote ControlPlaying at Random Repeating TracksUsing the Cassette Deck Listening to a Tape Reverse ModeStandard Play One touch playThings to know before you start recording Using the Cassette Deck RecordingStandard Recording CD Direct Recording One track recordingPress the CD #/8 button twice To stop at any time during the recording process, pressTo exit from AUX mode, select another source Using External EquipmentListening to External Equipment Setting the Daily Timer Using the TimersSetting the Clock Setting the Recording Timer Set the volume levelPress the Timer button on the Unit Select the music sourcePress the button to turn off the System Setting the Sleep TimerInsert a blank or erasable tape into the Cassette Deck Care and Maintenance Troubleshooting SymptomPossible Cause ActionSpecifications EN, GE, FR, NL, SP, IT 0100MWMMDWJEM