Impex MP-PWR10.0 manual Diagram

Page 9

STEP 3 (See Diagram 3)

A.) Attach the Leg Developer (#33) to the open bracket on the Main Frame (#27). Secure it with one M10 x 3 1/8” Allen Bolt (#76), two Ø ¾” Washers (#69), and one M10 Aircraft Nut (#72). Do not over tighten the bolt and nut, make sure Leg Developer is able to swivel.

B.) Insert the U-shaped Pin (#39) into the open tube on the Main Frame (#27). Secure it with one M6 x ½” Philips Screw (#43), Ø ½” Washer (#41), and Spring (#42). Pull and turn to lock the Leg Developer in position while using the bench at declined position.

C.) Insert three Foam Tubes (#38) halfway through the holes on the Main Frame and Leg Developer. Push six Foam Rolls (#60) onto the Tubes from both ends. Plug six Foam Roll End Caps (#56) into the ends.

D.) Slide an Olympic Sleeve (#44) onto the weight post on the Leg Developer.

E.) Attach the Curl Bar Holder (#34) to the Leg Developer and lock it with a L-shaped Pin (#40).

DIAGRAM 3

8

Image 9
Contents Marcy Platinum Toll-Free Customer Service Number Mon. Fri a.m. 5 p.m. PST Precautions Important Safety NoticeHardware Pack Hardware Pack Hardware Pack Diagram Assembly InstructionDiagram Diagram Diagram See Diagram See Diagram Diagram Cable Loop Diagram See Diagram 7 & Cable Loop Diagram See Diagram 8 & Cable Loop Diagram Diagram Page Rack Exploded Diagram ’ty Parts ListInfo@impex-fitness.com Impex INC