Impex MP-3105 manual Diagram

Page 22

STEP-10 (See Diagram 10)

A.) Attach the Seat Bracket (#95) to the pivot on the Main Seat Support (#92).

B.) Attach the two Backrest Supports (#97) to the Seat Bracket (#95) and align the holes. Secure them with a M12 x 8 ½” Allen Bolt (#113), two Ø 1” Washers (#111), and one

M12 Aircraft Nut (#112). Use the T-shaped Lock Pin on the Main Seat Support to lock the Seat Bracket at desired incline.

C.) Attach the Backrest Incline Support (#96) in between the two Backrest Supports (#97). Align the holes and secure it with a M12 x 8 ½” Allen Bolt (#113), two Ø 1” Washers (#111), and one M12 Aircraft Nut (#112). Place the other end of the Support onto the selected slot on the Main Seat Support.

D.) Do not over tighten the Nut and Bolt. Make sure the Backrest Supports and Backrest Incline Support are able to swivel.

E.) Insert the Foam Tube Frame (#99) into the opening on the Front Post (#94). Use the T- shaped Lock Pin to lock the Frame at desired height.

F.) Insert the Foam Tube (#100) half way through the hole on the Foam Tube Frame. Push

two Vinyl Foam Rolls (#106) onto the Tube from both ends. Plug two Foam Roll End Caps (#108) into the ends.

DIAGRAM 10

21

Image 22
Contents Smith Cage Toll-Free Customer Service Number Mon. Fri a.m. 5 p.m. PST Important Safety Notice Page Hardeware Pack Hardeware Pack Hardeware Pack Hardeware Pack Assembly Instruction Diagram See Diagram See Diagram Diagram See Diagram Cable Loop Diagram See Diagram 5 & Cable Loop Diagram Diagram See Diagram 6 & Cable Loop Diagram See Diagram 7 & Cable Loop Diagram Diagram Diagram Diagram Diagram Smith Machine Exploded Diagram Page Parts List ’tyImpex Info@impex-fitness.com