Assembly Instruction

Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen

Wrenches. NOTE: It is strongly recommended this machine to be assembled by two or more people to avoid possible injury.

STEP 1 (See Diagram 1)

A.)	Slide two Ø2 ½” Round Rubber Bumpers (#43) onto the Guide Rods (#7). Insert
	the two Guide Rods into the holes on the Rear Stabilizer (#8). Secure each Guide
	Rod with one M10 x 1” Allen Bolt (#72) and ∅ ¾” Washer (#77) from the bottom.
B.)	Attach the rear of Main Base Frame (#1) to the Rear Stabilizer. Secure them with
	two M10 x 2 ¾” Carriage Bolts (#62), one 4 3/8” x 2” Bracket (#20), two Ø ¾”
	Washers (#77), and two M10 Aircraft Nuts (#81). Do not tighten the nuts and bolts
	yet.

C.) Attach the Front Base Frame (#19) to the Main Base Frame (#1). Secure them

	with one M10 x 3” Allen Bolt (#74), one 4” x 2” Bracket (#29), two Ø ¾” Washers
	(#77), and one M10 Aircraft Nut (#81) to the top hole. Secure the bottom hole with
	one M10 x 2 ½” Allen Bolt (#64) and ∅ ¾” Washer (#77) from the back.
D.)	Attach the Front Stabilizer (#30) to the Front Base Frame. Secure them with two
	M10 x 2 ¾” Carriage Bolts (#62), one 4 ¾” x 2” Bracket (#22), two Ø ¾” Washers
	(#77), and two M10 Aircraft Nuts (#81).
E.)	Place the Vertical Frame (#2) onto the Main Base Frame. Secure them with two
	M10 x 3 ½” Carriage Bolts (#63), one Pulley Bracket (#18), two Ø ¾” Washers
	(#77), and two M10 Aircraft Nuts (#81). Securely tighten all nuts and bolts
	previously installed.