STEP 5 (See Diagram 5 & Cable Loop Diagram)
A.) | Attach the 283” Upper Cable (#48) to the swivel pulley |
| Right Lat Bar Frame (#9). Install a Ball Stopper (#46) onto the end of the Cable. |
| Attach the |
B.) | Attach a Short Chain (#30) in between the openings on the Connector and secure it |
| with a M10 x 1 3/8” Allen Bolt (#59), two ∅ ¾” Washers (#64), and one M10 Aircraft Nut |
| (#66). |
C.) | Draw the Cable over the Pulley and pull through the Cable sleeve on the Right Lat Bar |
| Frame. Draw the Cable along the Frame towards the back of the machine to the Pulley |
| previously installed. Draw the Cable around the Pulley then downward to the Double |
| Floating Pulley Bracket (#24). |
D.) | Attach two Pulleys (#36) to the Bracket. Secure them with a M10 x 2 ¾” Allen Bolt |
| (#55), two Ø ¾” Washers (#64), and one M10 Aircraft Nut (#66). |
E.) | Draw the Cable around the back Pulley then upward to the bottom of the Lat Bar Frame |
| Bracket (#20). Install a Pulley. |
F.) | Draw the Cable around the Pulley then back down to the Double Floating Pulley |
| Bracket (#24) again. Let the Bracket hanging for now. |
G.) | Draw the Cable around the front Pulley then upward towards the Pulley on the Left Lat |
| Bar Frame (#10). |
H.) | Draw the Cable over the Pulley then along the Left Lat Bar Frame (#10) towards the |
| front of the machine. Insert the Cable through the Cable sleeve and over the pre- |
| installed Pulley on the front of the Left Lat Bar Frame. |
I.) | Install a Ball Stopper (#46) at the end of the Cable and attach a |
| (#28) to the end. Attach a Short Chain (#30) in between the openings on the Connector |
| and secure it with a M10 x 1 3/8” Allen Bolt (#59), two ∅ ¾” Washers (#64), and one |
| M10 Aircraft Nut (#66). |
J.) | Connect the Lat Bar (#11) or Single Handles (#33) to the Short Chains using |
| (#32). |
12