See Diagram 8 & Cable Loop Diagram | Impex MWB-4360 instruction

STEP 8 (See Diagram 8 & Cable Loop Diagram)

A.) Un-install the M10 x 1 1/8” Allen Bolt (#104) and M10 Aircraft Nut (#86) on the U-shaped

Connector on one end of the 229” Cable (41). Remove the U-shaped Connector, Big Washer, and Ball Stopper from the Cable.

B.) Insert the end of Cable through the left Cross-over Swivel Pulley Bracket (#99). Attach a Pulley (#57) to the Swivel Bracket and secure it with one M10 x 1 ¾” Allen Bolt (#69), two Ø ¾” Washers (#66), and one M10 Aircraft Nut (#86). Draw the Cable over the Pulley and pull it towards the back of the machine.

C.) Draw the Cable along the Left Upper Frame (#94) to the opening on the rear of the Frame.

Drop the cable through the opening.

D.) Attach a Pulley to the opening. Secure it with one M10 x 2 ½” Allen Bolt (#70), two Pulley

Bushings (#62), and one M10 Aircraft Nut (#86). Draw the Cable around the Pulley then downward.

E.) Attach two Small Pulleys (#103) to the Triple Floating Pulley Bracket (#96). Secure them to

the Bracket with one M10 x 2 ¾” Allen Bolt (#105), two Ø ¾” Washers (#66), and one M10 Aircraft Nut (#86).

F.) Draw the Cable around the back Pulley then upward to the bracket underneath the Rear Upper Frame (#9). Install a Single Small Pulley Bracket (#98) to the bottom of Rear Upper Frame (#9). Secure it with one M10 x 1” Allen Bolt (#68), two Ø ¾” Washers (#66), and one M10 Aircraft Nut (#86). Install a Small Pulley to the Single Small Pulley Bracket.

G.) Draw the Cable around the Small Pulley then downward to the Triple Floating Pulley

Bracket. Draw the Cable around the front Small Pulley then upward to the opening on the rear of Right Upper Frame (#95). Let the Triple Floating Pulley Bracket hanging for now.

H.) Install a Pulley to the opening. Draw the Cable over the Pulley along the top of the Right

	Upper Frame through the cable sleeve to the right Cross-over Swivel Pulley Bracket. Install
	a Pulley to the Bracket.
I.)	Re-install the Ball Stopper, Big Washer and the U-shaped Connector previously removed in
	Procedure A above. Secure it with the M10 x 1 1/8” Allen Bolt (#104) and M10 Aircraft Nut
	(#86).
J.)	Connect a Single Handle (#90) to each end of the Cable with a C-clip (#61).

K.) When using the Lat Bar, remove one of the Single Handle and connect the Lat Bar to end of the Cable with a Short Chain (#63) and two C-clips (#61).