Assembly Instruction

Tools Required for Assembling the Machine: Two Adjustable Wrenches and

Allen Wrenches. NOTE: It is strongly recommended that two or more people assemble this machine to avoid possible injury.

STEP 1 (See Diagram 1)

A.)	Do not tighten the nuts and bolts until instructed to do so.
B.)	Slide two Ø 2 ½” x 1” Rubber Bumpers (#33) onto the Guide Rods (#10). Insert
	the two Guide Rods into the holes on the Rear Base Frame (#5). Secure each
	Guide Rod with one M10 x 1” Allen Bolt (#47) and ∅ ¾” Washer (#59) from the
	bottom.
C.)	Attach the rear of Main Frame (#1) to the Rear Base Frame. Secure them with two
	M10 x 2 ¾” Carriage Bolts (#46), one U-shaped Bracket (#16), two Ø ¾” Washers
	(#59), and two M10 Aircraft Nuts (#56).
D.)	Attach the Front Post (#6) to the Main Frame. Secure them with two M10 x 2 ¾”
	Carriage Bolts (#46), one 4 ¾” x 2” Bracket (#18), two Ø ¾” Washers (#59), and
	two M10 Aircraft Nuts (#56).
E.)	Attach the Seat Support (#17) onto the Main Frame. Secure them with two M10 x
	2 ¾” Carriage Bolts (#46), one 4 ¾” x 2” Bracket (#18), two Ø ¾” Washers (#59),
	and two M10 Aircraft Nuts (#56).
F.)	Attach the Foot Plate (#14) onto the Front Post. Secure it with two M10 x 5/8”
	Allen Bolts (#48) and two Ø ¾” Washers (#59).