Impex Olympic Cage manual See Diagram

Page 12

STEP 4 (See Diagram 4)

A.) Do not tighten the Nuts and Bolts until instructed to do so.

B.) Attach the Right Support (#3) to an Upright Beam (#1). Secure it with one M10 x 3 ½” Carriage Bolt (#86), ¾” Washer (#80) and M10 Aircraft Nut (#82). Attach the Side Support (#4) to the Upright Beam. Secure it with two M10 x 5/8” Allen Bolts (#98) and ¾” Washers (#80). Attach the other end to the Right Support. Repeat the same step to install the Left Support (#2) and Side Support to another Upright Beam.

C.) Connect the Left & Right Supports (#2 & #3) in the mid-span with a Cross Brace (#5). Secure each end with two M10 x 3 ¾” Carriage Bolts (#87), ¾” Washers (#80) and M10 Aircraft Nuts (#82).

D.) Attach the Rear Right Stabilizer (#8) to the Right Support (#3). Secure the upper hole with one M10 x 3 ½” Carriage Bolt (#86), ¾” Washer (#80), 4” Bracket (#26) and M10 Aircraft Nut (#82).

E.) Secure the lower hole with a M10 x 3 ½” Allen Bolt (#90) and ¾” Washer (#80). Repeat the same steps E & D to install the Left Rear Stabilizer (#7) to the Left Support (#2).

F.) Insert four Weight Posts (#20) into the holes on the Left & Right Supports. Secure each Post with one M10 x ¾” Allen Bolt (#97) and ¾” Washer (#80).

11

Image 12
Contents Marcy Platinum Toll-Free Customer Service Number Mon. Fri a.m. 5 p.m. PST Important Safety Notice Page Hardware Pack Hardware Pack Hardware Pack Hardware Pack Assembly Instruction Diagram Diagram See Diagram From the top Diagram Cable Loop Diagram See Diagram Diagram See Diagram 7 & Cable Loop Diagram Diagram See Diagram Page Page Parts List Impex INC