STEP 2 (See Diagram 2)
A.) Slide 9 Weight Plates (#66) onto the Guide Rods. Make sure the grooves on the Weight Plates are all facing the back of the machine and downward. Insert the Selector Rod (#47) through the center hole on the Weight Plates.
B.) Slide the Selector Stem (#65) onto the Guide Rods.
C.) Slide the Ring on the Selector Pin (#67) onto the Selector Rod. Insert the Selector Pin into the selected groove to choose the number of weight plates for exercise. Note: Each weight plate weights approximately 10 lbs.
D.) Attach the Upper Frame (#8) onto the two Guide Rods. Secure the two Guide Rods to the Upper Frame with two M10 x 1” Allen Bolts (#81) and Ø ¾” Washers (#86).
E.) Place the Upper Frame onto the Upper Vertical Frame (#15). Secure it with two M10 x 2 3/8” Carriage Bolts (#83), one 5 ½ Curved Bracket (#6), two Ø ¾” Washers (#86), and two M10 Aircraft Nuts (#90).
F.) Securely tighten all Nuts and Bolts previously installed.
G.)Attach the Front Press Base (#9) to the Upper Frame. Align the holes and insert an Axle (#32) through the holes. Secure each end of the Axle with one M10 x 5/8” Allen Bolt (#82) and one Ø ¾” Washer (#86).
H.) Place the Seat Pad (#37) onto the Seat Support (#5). Secure it with two M8 x 2 1/8” Allen Bolts (#73) and two Ø 5/8” Washers (#87).
I.) Attach the Arm Curl Pad (#36) to the Arm Curl Stand (#19). Secure it with two M8 x 5/8” Allen Bolts (#72) and Ø 5/8” Washers (#87). Insert the Arm Curl Stand into the opening on the Seat Support Frame. Use a Lock Knob (#68) to lock the Arm Curl Stand at desired height.
J.) Insert two Foam Tubes (#44) halfway through the holes on the Leg Developer and Seat Support. Push four Foam Rolls (#56) onto the Tubes. Plug four Foam Roll End Caps (#53) into the ends.
9