STEP 4 (See Diagram 4 & Cable Loop Diagram)
A.) | Attach the 122” Upper Cable (#40) to the open bracket underneath the front of |
| Upper Frame (#8). |
B.) | Attach a Pulley (#49) to the open bracket. Secure it with one M10 x 1 ¾” Allen |
| Bolt (#75), two Ø ¾” Washers (#86), and one M10 Aircraft Nut (#90). Note: The |
| Ball Stopper on the Cable should be underneath the Frame and Pulley. |
C.) | Draw the Cable towards the back of the machine to the open bracket under the |
| Upper Frame. Repeat Procedure B above to install another Pulley. |
D.) | Draw the Cable around the Pulley then pull back to the open bracket on the back |
| of Front Press Base (#9). |
E.) | Repeat Procedure B above to install another Pulley. |
F.) | Draw the Cable around the Pulley then to the open bracket on the back of the |
| Upper Vertical Frame (#15). Repeat Procedure B above to install another Pulley. |
G.) | Draw the Cable around the Pulley then downward. Attach the Cable to two |
| Double Floating Pulley Brackets (#43). Install another Pulley. Let the bracket |
| hanging for now. |
H.) | Pull the Cable around the Pulley then upward to the open bracket underneath |
| the Upper Frame between the two Guide Rods. Install a Pulley to the bracket. |
I.) | Pull the Cable downward between the two Guide Rods to the Selector Rod |
| (#47). Fully thread the bolt at the end of the Cable into the top opening on the |
| Selector Rod. |
J.) | Connect the Lat Bar (#21) to a Short Chain (#64) with a |
| connect the Short Chain to the Upper Cable with another |
K.) | Attach the Left Front Press Handle (#12) to the Left Butterfly (#10). Secure it with |
| one M10 x 2 1/8” Allen Bolt (#76) and Ø ¾” Washer (#86). Repeat the same |
| procedure to install the other side. Make sure the Handles are pointing toward |
| the back of the machine. |
13