Impex PHC 698 manual Diagram

STEP 4 (See Diagram 4)

A.) Place Backrest Board (#24) onto Backrest Supports (#22). Secure it with four M8 x 1 5/8” Allen Bolts (#35) and ∅ 5/8” Washers (#34).

B.) Place Seat (#25) onto the Seat Bracket (#19). Secure the two back holes with

two M8 x 5/8” Allen Bolts (#33) and ∅ 5/8” Washers (#34). Secure the two front holes with a Seat Incline Adjustment (#18), two M8 x 5/8” Allen Bolts (#33) and ∅ 5/8” Washers (#34). Insert a L-shaped Pin (#29) into the selected hole on the Seat Incline Adjustment to hold the desired incline.

C.) Insert one Foam Roll Tube (#30) halfway through the hole on the Leg Developer Holder. Insert two Foam Roll Tubes (#30) halfway through the holes on the Leg Developer (#17). Push six Foam Rolls (#31) onto the Tubes from both sides.

D.) Attach the Arm Curl Pad (#23) to the Arm Curl Stand (#26). Secure it with two M8 x 5/8” Allen Bolts (#33) and ∅ 5/8” Washers (#34). Insert Arm Curl Stand into the square opening on Upright Beam. For Arm Curl exercise, remove Leg Developer and insert Arm Curl Stand into the opening on top of Front Stabilizer.

E.) Attach two Spring Clips (#32) onto both ends of Curl Bar (#27). Insert the Curl Bar into the round opening on the Upright Beam.

DIAGRAM 4

7