Impex MWM-7300 manual See Diagram 5 & Cable Loop Diagram, Frame

STEP 5 (See Diagram 5 & Cable Loop Diagram)

A.)	Attach the 205” Upper Cable (#35) to the opening at the front of the Upper
	Frame (#5). Note: The Ball Stopper on the cable need to be underneath the
	Frame.
B.)	Attach a Pulley (#51) to the opening. Secure it with one M10 x 4 1/8” Allen Bolt
	(#77), two Ø ¾” Washers (#91), and one M10 Aircraft Nut (#94).
C.)	Draw the Cable towards the back of the machine to the opening on the Upper
	Frame. Repeat B to install a Pulley.
D.)	Draw the Cable around the Pulley then pull back towards the open bracket on
	the Front Press Base (#5).
E.)	Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#81),
	two Ø ¾” Washers (#91), and one M10 Aircraft Nut (#94).
F.)	Draw the Cable around the Pulley then to the opening on the Front Vertical
	Frame (#2). Repeat Procedure B above to install another Pulley.
G.)	Draw the Cable around the Pulley and back to the lower open bracket on Front
	Press Base. Repeat Procedure E to install a Pulley.
H.)	Draw the Cable around the Pulley and back to the open bracket on the back of
	Front Vertical Frame. Repeat Procedure E to install a Pulley.
I.)	Draw the Cable around the Pulley then downward. Attach the Cable to in
	between the two Double Floating Pulley Brackets (#20). Repeat Procedure E to
	install a Pulley. Let the bracket hanging for now.
J.)	Draw the Cable around the Pulley then pull the Cable upward to the open
	bracket on the Rear Vertical Frame (#3). Repeat Procedure E to install a Pulley.
K.)	Draw the Cable around the Pulley Along the Upper Cross Brace to the open
	bracket on the Upper Cross Brace (#15). Repeat Procedure E to install a Pulley.
L.)	Draw the Cable to the opening on the Weight Stack Frame (#17). Repeat B to
	install a Small Pulley (#50) to the opening.
M.)	Pull the Cable downward between the two Guide Rods, to the Selector Rod
	(#24). Fully thread the bolt at the end of the Cable into the top opening on the
	Selector Rod.
N.)	Use the Weight Selector Pin (#63) to select the number of Weight Plates to
	exercise. Please refer to the Weight Resistance Chart in page-24.

14