STEP 6 (See Diagram 6 & Cable Loop Diagram)
A.) Attach the 118” Lower Cable (#36) to the opening on the bottom of the Leg Developer (#10).
B.) Attach a Pulley (#51) to the opening. Secure it with one M10 x 3 3/8” Allen Bolt (#78), two Ø ¾” (#91), and one M10 Aircraft Nut (#94).
C.) Draw the Cable underneath the Pulley to the open bracket on Main Base Frame (#1). D.) Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#81), two Ø
¾” (#91), and one M10 Aircraft Nut (#94).
E.) Draw the Cable underneath the Pulley to the opening on the bottom of Front Vertical Frame (#2). Attach a Pulley to the opening. Secure it with one M10 x 4 1/8” Allen Bolt (#77), two Ø ¾” (#91), and one M10 Aircraft Nut (#94).
F.) Draw the Cable around the Pulley and then back in between the Right & Left Seat Swivel Support (#13) & (#14). Install a Pulley to the two Swivel Supports with one M10 x 7 ½” Allen Bolt (#76), two Ø ¾” Washers (#91), and one M10 Aircraft Nut (#94).
G.) Draw the Cable around the Pulley and then back to the open bracket on the back of
| Front Vertical Frame. Repeat Procedure D to install a Pulley. |
H.) | Pull up the Cable to the Double Floating Pulley Brackets (#20) installed in |
I.) | Repeat Procedure D to install a Pulley. |
J.) | Draw the Cable around the Pulley then downward to the bracket on the Rear Vertical |
| Frame (#3). Secure the end of Cable to the bracket with one M10 x 1” Allen Bolt |
| (#82), two Ø ¾” Washers (#91), one M10 Aircraft Nut (#94). |
K.) | Adjust the tension of the Cable by adjusting the Pulley position on the Double |
| Floating Pulley Bracket (#20). If the cables are too loose, move the Pulley up one |
| hole. If the cables are too tight, move the Pulley down one hole. |
L.) | For best performance of the machine, adjust the Cables so the Selector Stem (Top |
| Plate) on the weight stack is ¼” above the first plate. To select the weight, push |
| down on the Selector Stem to close the gap then insert the selector pin. This will |
| remove the slack in the cable system so the range of motion is smooth and tight. |
16