1. OPERATIONAL OVERVIEW

1.2Inserting a Chart Card

Your unit reads FURUNO and Nav-Charts(NAVIONICS) chart cards, or C-MAP chart cards, depending on the type of display unit you have. Insert the appropriate chart card for your area as follows:

1. Open the chart drive.

Chart drive

Card drive

Display unit

Memory card interface unit

 

(option)

2.Insert desired chart card groove side up.

3.Close the lid to protect the chart drive.

Note 1: Do not remove a card while the chart is being drawn. This may cause the equipment to freeze.

Note 2: Do not insert or remove a card while the power is on. This may cause the equipment to freeze.

Note 3: For multiple display units, do not use the same chart card type in more than one display unit.

Note 4: A card remover is supplied to ease removal of chart cards. Attach the card remover to the right-hand side hole of the card and pull it to remove the card. You can leave the remover attached to the card while the card is in the chart drive. Push the remover leftward until it contacts the recessed area on the card.

Chart card and card remover

1-5

Page 21
Image 21
Furuno 1823C manual Inserting a Chart Card, Display unit Memory card interface unit Option, Chart card and card remover