Furuno 1823C Selecting image source, Select source menu, Radar source and sounder source windows

1. OPERATIONAL OVERVIEW

1.5.4Selecting image source

When more than one network radar or network sounder is connected to the equipment, you may select an image source for each as shown below. This is not necessary when only one network radar or network sounder is connected.

1.Press the [DISP] key.

2.Press any soft key to show the following display.

▲RADAR SOURCE	RADAR - - -
SOUNDER SOURCE	SOUNDER-
AUX SOURCE	WXFAX - - -
IP ADDRESS	172.031.003.003
HOST NAME	RADAR - - -

SELECT SOURCE

EDIT

IF THERE IS MORE THAN ONE NETWORK RADAR OR ECHO SOUNDER, YOU MAY SELECT THE IMAGE SOURCES FOR DISPLAY.

RETURN

Select source menu

3.Use the trackball to select RADAR SOURCE, SOUNDER SOURCE or AUX SOURCE as appropriate, then press the EDIT key.

RADAR SOURCE

RADAR - - -

SOUNDER SOURCE

SOUNDER-

AUX SOURCE

WXFAX- - - - -

Radar source Sounder source Aux source

Radar source and sounder source windows

4.Use the trackball and alphanumeric keys to enter source name: Adjust the trackball to select location and enter character with the alphanumeric keys.

5.Push the [ENTER] knob to set.

6.Press the [DISP] key to finish.

7.Turn the power off and on again.

Note: Source names are determined at installation. For example, the source names for radars in a two radar system might be “RADAR” and “RADAR1”.

1-12