Furuno 1823C manual Outputting Data Through the Network, Select sentence menu

6.DATA TRANSFER

10.Press the RCV soft key followed by the [ENTER] knob.

The message “START RECEIVING DATA VIA NETWORK.” is displayed. If no data could be found, the message “(HOST NAME)’ IS NOT FOUND.” appears.

11.When the transfer is completed, the message “DATA TRANSFER COMPLETED. PUSH ENTER KNOB TO CONTINUE.” appears. Push the [ENTER] knob to finish.

12.Press the [MENU] key to close the menu.

6.5Outputting Data Through the Network

Follow the procedure below to output data through the network.

1.Press the [MENU] key to open the menu.

2.Press the SYSTEM CONFIGURATION, SYSTEM SETUP, PORT SETUP and OUTPUT THROUGH NETWORK soft keys.

SELECT SENTENCE

AAM	--
APB	--
BOD	--
BWR	--
DPT	--
GGA	--
GLL	--
GTD	--
MTW	--
RMA	--
RMB	--
RMC	--
VHW	--
VTG	--
WPL	--
XTE	--
ZDA	--
HDT	--
HDG	--
MWV	--

SELECT SNTNC

ON/OFF

RETURN

Select sentence menu

3.Select sentence with the trackball.

4.Press the ON/OFF soft key to turn sentence on or off.

5.Press the RETURN soft key.

6.Press the [MENU] key to close the menu.

AAM: Waypoint arrival alarm, APB: Autopilot sentence B, BOD: Bearing origin to

destination, BWR: Bearing and distance to waypoint - rhumb line, DPT: Depth,

GGA: Global positioning system(GPS) fix data, GLL: Geographic position -

latutude/longitude, GTD: Own ship information-TD, MTW: Water temperature,

RMA: Recommended minimum specific LORAN-C data, RMB: Recommended

minimum navigation information, RMC: Recommended minimum specific

GPS/TRANSIT data, VHW: Water speed and heading, VTG: Course over ground

and ground speed, WPL: Waypoint location, XTE: Cross-track error, measured,

ZDA: Time and date, HDT: Heading true, HDG: Heading, deviation and variation,

MWV: Wind speed and angle

6-10