Furuno 1823C manual Turning the Unit On/Off, Startup sequence

1. OPERATIONAL OVERVIEW

1.3Turning the Unit On/Off

Press the [POWER/BRILL] key to turn the unit on. A beep sounds and the equipment proceeds in the sequence shown below, displaying product information, startup test results and the chart usage disclaimer. The startup test checks the ROM, RAM, internal battery and backup data for proper operation, displaying the results for each as OK or NG (No Good). If NG appears an appropriate message appears on the screen. For any NG, try to press any key to go to the chart disclaimer screen, then perform the diagnostic test as shown in the paragraph “7.6 Diagnostics.”

Chart List

Host Name

RADAR PLOTTER*

STATION NAME: RADAR#

FURUNO ELECTRIC CO., LTD. CHARTS AVAILABLE

LICENSE NO.

*= "GD-1900C Plotter" for GD-1900C #= Name determined at installation.

	STARTUP TEST
	ROM	OK
	RAM	OK
	BACKUP DATA	OK
Î	INTERNAL BATTERY	OK

**= Program version no. for￿

FURUNO/NAVIONICS￿

model. 19500010XX for C-MAP model.￿ XX = program version no.

NO NATIONAL HYDROGRAPHIC￿

OFFICE HAS VERIFIED THE￿

INFORMATION IN THIS￿

COASTLINE DATA CARD AND NONE￿

ACCEPT LIABILITY FOR THE ￿

ACCURACY OF REPRODUCTION OR￿

ANY MODIFICATIONS MADE ￿

ÎTHEREAFTER. THIS PRODUCT WITH￿ THIS COASTLINE DATA CARD￿ DOES NOT REPLACE THE ￿ REQUIREMENT TO USE THE￿ APPROPRIATE PRODUCTS FOR￿ NAVIGATION ACCORDING TO￿ NATIONAL AND INTERNATIONAL￿ REGULATIONS.

￿

PROGRAM No. 19500020XX**

Startup sequence

For start up with the radar display, the magnetron takes from one minute to two minutes and thirty seconds (depending on radar model) to warm up before the radar can be operated. The time remaining for warming up of the magnetron is counted down at the center of the display.

You may press any key at the chart disclaimer screen to show the last-used display, or wait several seconds to let the equipment do it for you.

To turn the unit off, press and hold down the [POWER/BRILL] key until the screen goes dark (approx. 3 sec.). To protect the LCD attach the hard cover. Note that the network sounder will be turned off approx. three minutes after turning off the power.

Note: The first time you turn on the power (or any time the power is applied after a memory reset), you are asked if you want to start the simulation mode, which provides simulated operation of the equipment. Push the [ENTER] knob to start the simulation mode, or press the [CLEAR] key to start normal operation. For further details about the simulation mode, see the paragraph “1.10 Simulation Display.”

1-6