Impex PHC 715 manual Assembly Instruction, Diagram

Page 5

ASSEMBLY INSTRUCTION

Tools Required to Assemble the Machine: Two Adjustable Wrenches and Allen Wrenches.

NOTE: It is strongly recommended this machine to be assembled by two or more people to avoid possible injury.

STEP 1 (See Diagram 1)

A.)

Connect the Rear Upright Beams (#1) by a Cross Brace (#5) in the mid-span. Align the holes

 

and secure them with one Triangle Bracket (#12), one Bent Bracket (#13), two M10 x 3 ½”

 

Carriage Bolts (#34), two M10 x 2 3/8” Carriage Bolts (#36), four ¾” Washers (#43), and

 

four M10 Aircraft Nuts (#42) on each end of the Cross Brace.

B.)

Attach the Front Stabilizer (#2) to the front of the Main Seat Support (#3). Secure it with one

 

M10 x 2 ½” Carriage Bolt (#51), two M10 x 2 ¾” Carriage Bolts (#35), ¾” Washers (#43),

 

and M10 Aircraft Nuts (#42).

C.)

Attach the back of the Main Seat Support (#3) to the Cross Brace (#5). Secure it with one

 

Bracket (#14), two M10 x 2 3/8” Carriage Bolts (#36), ¾” Washers (#43), and M10 Aircraft

 

Nuts (#42).

D.)

Insert two Crutches (#7) into the top openings on the Upright Beams. Secure them with two

 

Lock Knobs (#33) through selected holes to obtain desired height of the Supports.

E.)

Place Backrest Adjustment Bar (#8) between the two Upright Beams on the selected bar

 

holder to obtain desired incline of Backrest.

DIAGRAM 1

4

Image 5
Contents Powerhouse Club Before YOU Begin Table of ContentsImportant Safety Notice Page Diagram Assembly InstructionDiagram Diagram Diagram Page KEY NO. Description Parts ListImpex INC