A.) | Connect the Front Stabilizer (#42) to the Main Seat Support (#52) and secure them with |
| two M10 x ¾” Hex Bolts (#46), four ∅ ¾” Washers (#3), and two M10 Aircraft Nuts (#4). |
| DO NOT tighten the nuts and bolts yet. |
B.) | Connect the Main Seat Support (#52) to the open bracket on the Cross Brace (#59). |
| Secure the rear hole on the bracket with one M10 x 2 3/8” Bolt (#2), two ∅ ¾” Washers |
| (#3), and one M10 Aircraft Nut (#4). Secure the other hole with a 3” Lock Pin (#58). |
| Note: DO NOT over tighten the nut and bolt. The Main Frame needs to pivot on this |
| bolt in able to fold up the bench. |
C.) | Connect one end of Diagonal Support (#43) to the Main Seat Support (#52). Secure it |
| with one M8 x 2 1/8” Hex Bolt (#48), two ∅ 5/8” Washers (#21) and one M8 Aircraft Nut |
| (#49). Connect the other end to the Front Stabilizer. Secure it with one M8 x 5/8” Hex |
| Bolt (#20) and ∅ 5/8” Washer (#21). |
D.) | Securely tighten all the nuts and bolts previously installed. |
E.) | Insert 6 ½” Long Lock Pin (#53) into the hole on the Main Seat Support (52). NOTE: |
| The Pin is not designed to sustain any heavy weight. Only use the pin when changing |
| the backrest board to a vertical position when doing |
| DIAGRAM 2 |
5
STEP 3 (SEE DIAGRAM 3)