STEP 2 (See Diagram 2)
A.) Attach the Main Seat Support (#4) to the Cross Brace (#3). Secure it with one 5 ½” x 3” Bent Bracket (#25), four M10 x 2 3/8” Carriage Bolts (#48), four Ø ¾” Washers (#59) and four M10 Aircraft Nuts (#46).
B.) Attach the seat support frame on the Leg Developer Holder (#5) to the bracket on the Main Seat Support (#4). Secure it with one M10 x 2 ¾” Allen Bolt (#50), two Ø ¾” Washers (#59), and one M10 Aircraft Nut (#46). Do not tighten the Nut and Bolt yet.
C.) Attach the bottom of Leg Developer Holder (#5) to the Main Seat Support. Secure it with one Bracket (#19), two M10 x 2 3/8” Allen Bolts (#51) and two Ø ¾” Washers (#59). Securely tighten all the Nuts and Bolts previously installed.
D.) Place the Seat (#22) onto the seat support frame on the Leg Developer Holder. Secure it with four M8 x 5/8” Allen Bolts (#55) and Ø 5/8” Washers (#58).
E.) Thread the Lock Knob (#29) into the hole on the Leg Developer Holder.
F.) Insert a Foam Tube halfway through the hole on the Leg Developer Holder. Push two Vinyl Foam Rolls (#32) onto the Tube from both ends. Push two Foam Roll End Caps (#39) into the ends.
DIAGRAM 2
8