Assembly Instruction

Tools Required for Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches.

NOTE: It is strongly recommended that two or more people assemble this machine to avoid possible injury.

STEP 1 (See Diagram 1)

A.) Do not tighten the Nuts and Bolts until instructed to do so.

B.) Attach the Left Diagonal Support (#3) to an Upright Beam (#1). Secure the top & bottom to the Upright with four M10 x ¾” Allen Bolts (#51) and four Ø ¾” Washers (#54). Repeat the same procedure to install the Right Diagonal Support (#4) to another Upright Beam.

C.) Connect the Left & Right Diagonal Support (#3) & (#4) with a Cross Brace (#2) in the mid- span. Secure each end with two M10 x 2 ¾” Carriage Bolts (#46), one 5 ½” x 2” Bracket (#27), two Ø ¾” Washers (#54), and two M10 Aircraft Nuts (#56).

D.) Securely tighten all Nuts and Bolts installed.

E.) Insert two Weight Posts (#7) into the Left & Right Diagonal Support. Secure each Weight Post with one M10 x ¾” Allen Bolt (#51) and one Ø ¾” Washer (#54). Slide an Olympic Sleeve (#43) onto each Weight Post. Attach a Spring Clip (#29) onto each Sleeve.

F.) Attach the two Safety Catches (#5) onto the Upright Beams, and then attach the two Bar Catches (#6) onto the Upright Beams. Use a 3 5/8” Long Pin (#21) to lock each Safety Catch and Bar Catch at selected position.