STEP 4 (See Diagram 4)
A.) Attach the Leg Developer (#13) to the leg developer holder on the Main Seat Support (#9). Secure it with one M10 x 3 ½” Allen Bolt (#48), two ∅ ¾” Washers (#54), and one M10 Aircraft Nut (#56).
B.) Insert two Foam Tubes (#14) halfway through the holes on the Leg Developer. Push four Foam Rolls (#39) onto the Tubes from both ends. Plug four Foam Roll End Caps (#38) into the ends.
C.) Slide an Olympic Sleeve (#43) onto the weight post on the Leg Developer. Attach a Spring Clip (#29) to the Sleeve.
D.) Attach the Arm Curl Handle (#15) to the open bracket on the Leg Developer. Secure it with a Lock Pin (#22).
DIAGRAM 4
8