STEP 14 (See Diagram 14)
A.) | Place a Seat Pad (#32) onto the Right Seat Support (#7). Secure it with two M8 x 2 3/8” Allen |
| Bolts (#91) and ∅ 5/8” Washers (#98). |
B.) | Attach a Backrest Board (#33) to the Right Vertical Beam (#3). Secure it with two M8 x 2 3/8” |
| Allen Bolts (#91) and ∅ 5/8” Washers (#98). |
C.) | Insert two Foam Roll Tubes (#41) halfway through the holes on the Right Seat Support (#7) |
| and Leg Developer (#19). Push four Foam Rolls (#47) onto the Tubes from both sides. Plug |
| four Foam Roll End Caps (#62) into the ends. |
D.) | Attach the Arm Curl Pad (#34) to the Arm Curl Stand (#21). Secure it with two M8 x 5/8” Allen |
| Bolts (#90) and ∅ 5/8” Washers (#98). Insert the Arm Curl Stand into the opening in front of |
| the seat. Use the M18 Lock Knob (#61) to secure the desired position. |
E.) | Connect the Lat Bar (#22) to the Upper Cable with two |
F.) | Connect the Arm Curl Handle (#42) to the Front Press Cable (#36) with two |
| a Long Chain (#104). |
23