STEP 6 (See Diagram 6)
A.) | Attach an Upright Beam (#49) to a Floor Stabilizer (#47). Secure it with two M10 x 2 3/4” |
| Carriage Bolts (#81), ∅ ¾” Washers (#42), and M10 Aircraft Nuts (#44). Do not tighten |
| the nuts and bolts yet. |
B.) | Attach the upper end of Left Support (#50) to the Upright Beam. Secure it with one M10 x |
| 5/8” Allen Bolt (#88) and ∅ ¾” Washer (#42). |
C.) | Attach the lower end of Left Support (#50) to the Floor Stabilizer (#47). Attach one end of |
| the Rear Stabilizer (#53) to the Floor Stabilizer. Align the holes and secure them with two |
| M10 x 3 ¾” Carriage Bolts (#83), ∅ ¾” Washers (#42) and M10 Aircraft Nuts (#44). |
D.) | Repeat Steps A, B and C above to install the other side. |
E.) | Securely tighten all Nuts and Bolts. |
| DIAGRAM 6 |
10