STEP 2 | (SEE DIAGRAM 2) | |
A.) | Connect the Front Stabilizer (#42) to the Main Seat Support (#52) and secure them with | |
| two M10 x ¾” Hex Bolts (#46), four ∅ ¾” Washers (#3), and two M10 Aircraft Nuts (#4). | |
| DO NOT tighten the nuts and bolts yet. | |
B.) | Connect the Main Seat Support (#52) to the open bracket on the Cross Brace (#15). | |
| Secure the rear hole on the bracket with one M10 x 2 3/8” Bolt (#2), two ∅ ¾” Washers | |
| (#3), and one M10 Aircraft Nut (#4). Secure the other hole with a 3” Lock Pin (#8). Note: | |
| DO NOT over tighten the nut and bolt. The Main Frame needs to pivot on this bolt in able | |
| to fold up the bench. | |
C.) | Connect one end of Diagonal Support (#43) to the Main Seat Support (#52). Secure it | |
| with one M8 x 2 1/8” Hex Bolt (#48), two ∅ 5/8” Washers (#21) and one M8 Aircraft Nut | |
| (#49). Connect the other end to the Front Stabilizer. Secure it with one M8 x 5/8” Hex Bolt | |
| (#20) and ∅ 5/8” Washer (#21). | |
D.) | Securely tighten all the nuts and bolts previously installed. | |
E.) | Insert 6 ½” Long Lock Pin (#53) into the hole on the Main Seat Support (52). NOTE: The | |
| Pin is not designed to sustain any heavy weight. Only use the pin when changing the | |
| backrest board to a vertical position while doing | |
DIAGRAM 2
5