CITIZEN QUARTZ
DIGI-ANA MARINE
Model No. JG1❈❈❈
Caliber No. C350
•INSTRUCTION MANUAL
CTZ-E6792
When reading this instruction manual please keep the watch diagram at left folded out and in view. Symbols used in the sections on operating instructions refer to the symbols indicated in this diagram.
Thank you very much for purchasing a CITIZEN QUARTZ WATCH. To ensure correct use, please read these instructions carefully. Please ensure that the Citizen international guarantee card is supplied with watch on purchase, that you may claim the guarantee service (subject to the terms of guarantee).
1. Features
This watch has an EL
2. Operating Instructions
3. Switching Modes (Functions)
In addition to the time/calendar mode, the watch has four modes: Alarm 1, Alarm 2, Chronograph and Timer. Each time button M is pressed, the mode display is switched in the following order:
[TIME] ➝ [ALM1] ➝ [ALM2] ➝ [CHR] ➝ [TMR].
Note: If the watch is left in the ALM1 or ALM2 mode for 2 to 3 minutes, the display automatically returns to TIME mode.
4.EL (Electro Luminescence) Illumination While pressing button A , with the crown in any position, the display is illuminated.
[EL]
EL panel of this watch is a fluorescent panel which illuminates when voltage is applied to it.
[Characteristics and replacement of the EL panel] The electro luminescence panel has the following properties.
• When the battery voltage drops, the brightness (intensity) also drops.
• It is adversely affected by humidity.
If any water enters inside the watch by accident, promptly request repair.
• The EL panel has a finite life span.
The brightness (intensity) gradually drops in proportion to the total number of hours of use (light emission).
If the display appears dark or is hard to see when the EL panel comes on, ask either the store where you purchased the product or your nearest CITIZEN Service Centre to replace the EL panel.
This repair will be done for a fee.
5.Setting the Time and Calendar
A. Digital setting
1)While in the time mode, press button C for one second or more, seconds will flash and switch to correcting state.
2)While seconds flash, press buttonB to reset the seconds to “00” after that seconds start again.
3)When in the seconds correcting state (second flash), press buttonC , the flashing digit will change in order of
4)Correct the flashing digit by pressing buttonB . (Press and hold down button B quick advance to flashing digit.)