Citizen JG1 Timer time up and auto-chronograph feature, Auto-chronograph feature

[Timer time up and auto-chronograph feature]

•At the end of a timing session, an end of session confirmation beep sounds for 5 seconds, the watch switches to the chronograph measurement starts. (Auto-chronograph feature)

✩Auto-chronograph feature

The auto-chronograph feature can measure up to 24 hours in 1 second start from timer time up.

•Press button B to stop measurement.

•Press button B again to repeat the start and stop cycle.

•Press button C to reset chronograph.

*This auto-chronograph can not use to split measurement.

[A time up warning beep sounds ON/OFF feature] Can be switched ON or OFF of a time up warning beep sounds by pressing button B during pressing button A . When switch to ON, timer mode mark will flash.

A time up warning beep sounds once at the following intervals: before the time is up 5, 4, 3, 2, 1 minutes and every 10 seconds from 50 to 10, 9, 8, ……5, 4, 3,

2, 1.

✩Fly back feature

The flyback feature is used to restart the timer anytime after the timer has already been started Press button C anytime during a timer counting, a confirmation beep will sound and the timer restart the moment.

9. All-Reset Operation

After replacing the battery or when the watch’s display is unusual due to strong shock or intense static electricity. (No display, alarm continuously sounds etc.) Perform the all-reset operation as follows:

1)Press buttons A , B , C , and M simultaneously.

2)Release the buttons. All the display segments will appear.

3)Press any buttons A , B , C , or M . At that time confirmation will sound. The all-reset operation is complete. Setting each mode again before using.

10.Precautions Water resistance

“WATER RESISTANT” may sometimes be	* Always set the crown in the normal position
abbreviated as “WATER RESIST”