11 | Troubleshooting Guide |
There is a crackling noise coming from my speakers
Note:
I turn up the volume but it isn’t very loud
Note:
There is no output from my system
Please use this guide if you are experiencing any problems with the SXV2 in your system. It will provide possible solutions for some given symptoms.
Output signal is clipping
The SXV2 gain setting is too high. Confirm that the gain is configured correctly for your cartridge. If you are unsure, decrease the gain setting step by step until the crackling noise goes away.
Ensure you switch the unit off before adjusting the DIP switches.
Dust on needle and/or record
Make sure that your needle and record are free from dust and debris.
Output level is too low
The SXV2 gain setting is too low. Confirm that the gain is configured correctly for your cartridge. If you are unsure, increase the gain setting step by step until the volume level is suitable.
Ensure you switch the unit off before adjusting the DIP switches.
Incorrect cartridge loading
The resistive and capacitive cartridge loading configurations are not set correctly. Check that these settings match the requirements of your cartridge.
SXV2 not turned on
Make sure the SXV2 power switch is in the DOWN position.
AC cord not plugged in
Check that the AC cord is plugged into the IEC socket on the rear of the SXV2.
23