Under CS operation mode, the timer, after counting down to 0:00'00", will stay at 0:00'00"0 until you press [RESET] to reload the timer value.
Under CU operation mode, the timer, after counting down to 0:00'00"0, will count up and stop at 19:59'59"9.
How to set the timer
Press and hold [RECALL] for 2 seconds to activate timer setting. Timer setting starts with second digits, which are shown blinking. You can press [START] to advance the flashing digits. Or you can press [RESET] to select other digits. The setting is in sequence of second, minute, hour and timer operating mode (CR, CS and CU).
NOTE: You can only set Hour, Minute and Seconds. The 1/10 second cannot be set.
Press and hold [RECALL] for 2 seconds. Timer setting starts with second digits.
Press [RESET] to move to minute digits.
Press [RESET] further to go to hour digits. Hour digits can be adjusted from 0 to 19.
Press [RESET] again to adjust the operating mode. Press [START] to switch the operating modes among CR, CS and CU.
{000} | 0: 00' 00" 0 |
CR | 0: 00' 00" 0 |
A | 12 : 58' 55 |
|
|
{000} | 0: 00' 00" 0 |
CR | 0: 00' 00" 0 |
A | 12 : 58' 57 |
|
|
{000} | 0: 00' 00" 0 |
CR | 0: 00' 00" 0 |
A | 12 : 59' 02 |
|
|
{000} | 0: 00' 00" 0 |
CR | 0: 00' 00" 0 |
A | 12 : 59' 11 |
At the end of setting, press [RECALL] or [MODE] to leave setting mode. | 13 |