9.Use the right Tricycle for the situation. There are certain applications for which this Tricycle was designed. Do not modify this Tricycle and do not use this Tricycle for a purpose for which it was not intended.
10.Only one person allowed on the Tricyle at any time. Only one seated rider should be on the Tricycle at a time. No other passengers should be standing on the rear of the frame, or sitting on the handlebars.
11.The Tricycle is meant for
12.Do not exceed the maximum weight capacity of 250 Lbs.
13.Always make sure tires are properly inflated (see page 2).
WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking your Tricycle with Pneumatic Tires, check to make sure all parts listed on page 5 are included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at
Assembly
Your Rolling Tricycle with Pneumatic Tires will require complete assembly. It is important that you read the entire manual to become familiar with the product BEFORE you assemble and use the Tricycle. Before assembling the Tricycle be sure that you have all parts described in the Parts List and Assembly Diagram located on the last pages of this manual.
THE RIDER OF THE TRICYCLE MUST BE AT LEAST 48”TALL TO PROPERLY REACH THE PEDALS.
Handlebars
1.To attach the Handlebar (1), loosen Nut (31) and slide out Bolt (33) and Washer (32). Insert Handlebar
2.Slide a Grip (2) onto the end of each Handlebar (1).
3.Insert the Handlebar (1) and Stem (8) down through the Locknut (5), Upper Cap (7), and Bearing Ring (36) and into the Frame (13).
Figure 1
Lock Bolt (3)
Handlebar (1)
Bolt (33)
Washer (32)
Nut (31)
Stem (8)
SKU 94142 | For technical questions please call | Page 3 |