Jumpking YJ manual 6RFNHW

6.Using the included plastic tie, attach the Safety Placard (11) to the frame near the point where jumpers will climb onto and off the trampoline.

The trampoline is now fully assembled. Make sure that all parts are securely attached.

Familiarize yourself and all users of the tram- poline with the safety precautions, use and instructional materials, and care and mainte- nance instructions in this manual before using the trampoline.

7.Loosen the straps (not shown) on the underside of the frame pad (for clarity, the frame pad is not shown in the steps 8 and 11). Do not remove the frame pad from the trampoline.

See the inset drawing.

8.Lay a Straight Tube(16) and a Top Tube (17) with Plastic Cap on the ground.

Make sure that the Straight Tube (16) is oriented so the small holes are in the position shown. Slide a Foam Sleeve (21) onto each of the tubes; note that the ends of the Straight Tube (16) should not be covered.

Insert the Straight Tube (16) into the Top tube(17). Tighten a Self-tapping Screw (12) into the small hole in the Tube (16,17).

Assemble the remaining Straight Tubes (16), Top Tubes (17), and Foam Sleeves (21) in the same way.

9.Slide a ‘WEDGE’(23) onto the

Straight Tube(16), the top of the ‘Wedge’(23) should touch the bottom of the T-Connector(4), and that the bottom of the ‘Wedge’ (23) should be even with the bottom of the straight tube. Slide one of the U-bolts(15) up until it touches the bottom of the T-connector(4), and tighten the two Locknuts(13) on the U-bolt. Slide the other U-bolt up until it is 2” above the lower end of the Straight tube,and tighten the two Locknuts on the U-bolt. Then, press two U-bolt Plastic Caps(24)

onto each U-bolt.

6
		Frame
		

			6RFNHW
		
		
			
		
			
	15		
	14
	24
	13
		8EROWV
	
			
			
			
		6PDOO+ROH	
			
	
			3ODVWLF&DS
			
		


7LJKWHQ6HOIWDSSLQJ6FUHZ			3ODVWLF&DS
			
,QWR6PDOO+ROH

		
		
		T-connector
		  	
			
		
			

18