Precor S3.15 manual Install the Multi-Hip Cable

S3.15 Multi-Hip Option Assembly Instructions

3. Install the Multi-Hip Cable

A.Feed the tab end of the Multi-Hip Cable 130194 between the two 3½-inch pulleys on the Multi-Hip Upright and attach the cable to the Selector Hub using

one shaft two e-clips

B.Remove the lower 3¹⁄₂-inch pulley on the Multi-Hip Upright. Feed the cable around it and reattach it using

one 4-inch hex head bolt two shoulder spacers one locknut

C.Remove the 3¹⁄₂-inch pulley from its pulley bracket. Feed the cable around it and reattach it using one 2¼-inch hex head bolt

two flat washers one locknut

D.Wrench tighten all pulley fasteners.

Pulley assemblies

3½-inch Pulley (used on gray painted parts)

1 - bolt

2 - shoulder spacers

1 - locknut

3½-inch Pulley (used on titanium parts)

1 - zinc bolt

2 - zinc washers

1 - zinc locknut

1 - 2¼" bolt

2 - washers

1 - locknut

Selector Hub

1 - shaft

2 - e-clips A

Multi-Hip

Upright

C

1 - 4" bolt

B 2 - 1" shoulder spacers 1 - locknut

1

2

3

4

5

6

Step 3. Install the Multi-Hip Cable

page 9