Precor manual Attach the Multi-Hip to the S3.15

S3.15 Multi-Hip Option Assembly Instructions

1.Attach the Multi-Hip to the S3.15

Important: Most fasteners are fitted to the frame or pulley, you will need to disassemble the fasteners before proceeding with each step.

A.Attach the Multi-Hip Base to the S3.15 Rear Crossbar using

three 1¼-inch hex head bolts three flat washers

three spring washers three locknuts

B.Position the Crossbrace against the S3.15 Main Base and place it on top of the Multi-Hip flange. Attach the Crossbrace to the Multi-Hip using two 2¹⁄₄-inch hex head bolts

two flat washers

C.Attach the Crossbrace to the S3.15 Main Base using

two 4¹⁄₄-inch hex head bolts four radius washers

two locknuts

Note: If you plan to install the S3.15 Leg Press Option immediately after you complete the Multi- Hip Option assembly, place two washers and two locknuts on the fastener ends finger tight so they provide stability, but can easily be removed.

				2 - 2¹⁄₄" bolts	B
				2 - washers
	Rear			Crossbrace	Multi-Hip Flange
	Crossbar
			Multi-Hip
			Upright
	Spring
	Washer
	3	- 1¼" bolts
	A 3	- flat washers	Main Base
	3	- spring washers
	3	- locknuts
		2 - 4¹⁄₄" bolts		C
		4 - radius washers
		2 - locknuts
1	2	3		4	5	6

Step 1. Attach the Multi-Hip to the S3.15

page 7