IMPORTANT!
ONCE POLE SECTIONS ARE POUNDED TOGETHER- THEY CANNOT BE TAKEN APART
Align poles using alignment marks. First, pound top and
2. middle poles together by bouncing them on a scrap piece of wood on the ground as shown in FIG B. until they no longer move toward pole identification stickers. THEN add bottom pole section and pound together in the same way.
CAUTION!
THE IDENTIFICATION STICKER IS LOCATED 5" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A
MINIMUM OVERLAP, LEAVING 1- 1/2" BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.
alignment mark
TOP
4
alignment mark
FIG B.
scrap wood (Not Supplied)
IDENTIFICATION STICKER 
middle pole
5"
MIDDLE
5
alignment mark
IDENTIFICATION STICKER 
middle pole
BOTTOM
6
P/N 21273401 07/28/04 | 8 |
http://www.huffysports.com