IMPORTANT!
ONCE POLE SECTIONS ARE POUNDED TOGETHER- THEY CANNOT BE TAKEN APART
Align poles using alignment marks. First, pound top and
2. middle poles together by bouncing them on a scrap piece of wood on the ground as shown in FIG A. until they no longer move toward pole identification stickers. THEN add bottom pole section and pound together in the same way.
CAUTION!
THE IDENTIFICATION STICKER IS
LOCATED
THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE POLE
SECTIONS SHOULD HAVE A
MINIMUM OVERLAP, LEAVING
BETWEEN THE OVERLAPPING POLE
AND THE IDENTIFICATION STICKER.
alignment mark
TOP
2
alignment mark
MIDDLE
FIG A.
scrap wood (Not Supplied)
IDENTIFICATION
STICKER
middle pole
3
alignment mark
BOTTOM
IDENTIFICATION |
|
STICKER | |
| |
| middle pole |
4
ID# M580001 05/05 | 8 |