Huffy 89225 manual Safety Instructions

Page 3

NOTICE TO ASSEMBLERS

ALL Huffy Sports Basketball Systems, including those used for DISPLAYS, MUST be assembled and ballasted with sand or water according to the instructions. Failure to follow instructions could result in SERIOUS INJURY. It is NOT acceptable to devise a makeshift weight system.

IMPORTANT!

Remove all contents from boxes.

Be sure to check inside pole sections; hardware and additional parts are packed inside.

SAFETY INSTRUCTIONS

FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY

RESULT IN SERIOUS INJURY,

PROPERTY DAMAGE AND WILL VOID WARRANTY.

This unit is intended for display purposes only and

should not be used for play.

To ensure safety, do not attempt to assemble this system without following the instructions carefully. Check entire box and inside all packing material for parts. Before beginning assembly, read the instructions and identify parts in this document. Proper and complete assembly, use and supervision is essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly.

During assembly, if using a ladder use extreme caution. Two people are recommended for this operation.

If technical assistance is required, contact Huffy Sports’ Sample and Display Technician.

Serious injury could occur if teeth/face come in contact with backboard, net or rim.

Display recommended for 3” (7.6 cm) or 3-1/2” (9 cm) Round or 4” (10 cm) Square poles only.

All instructions and warnings MUST accompany any display item that is sold.

Most injuries are caused by misuse and/or not following

instructions.

Use caution when installing this unit.

3

P/N 21154401

01/04

Image 3
Contents Display System Before YOU Start Safety Instructions Parts List See Hardware Identifier Hardware Identifier Springs & Washers Display Stand Top View 12 QTY 39 QTY 13 QTY Elevator Assembly Corner Location Steel Frame Acrylic Backboard Assembly Corner Location 01/04 01/04 Tighten nut 35 until FAN Molded Plastic Board Assembly Corner Location Hook one end of the spring 36 into hole 01/04 Tighten nut 35 until Flush with end of T bolt As shown here Press Bracket 20 Into Place Here FAN Backboard Assembly Corner Location Clip ARM Clip Body Install net Insert net into bottom of clip as shown