Huffy 89225 manual QTY 39 QTY 13 QTY

Page 7

At corner locations 1, 2, and 3 install the display pole to the mounting pole stub. If required,

1. secure the display pole by sliding the display wedge (12) into position as shown. To lock the display pole in place, tighten the set screw (13 or 39).

12: QTY 3

39:QTY 1

13:QTY 2

2. At corner location 4 slide the display pole (14) (3 1/2” diameter) over the mounting pole stubs.

10

7

P/N 21154401

01/04

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Display System Before YOU Start Safety Instructions Parts List See Hardware Identifier Hardware Identifier Springs & Washers Display Stand Top View 12 QTY 39 QTY 13 QTY Elevator Assembly Corner Location Steel Frame Acrylic Backboard Assembly Corner Location 01/04 01/04 Tighten nut 35 until FAN Molded Plastic Board Assembly Corner Location Hook one end of the spring 36 into hole 01/04 Tighten nut 35 until Flush with end of T bolt As shown here Press Bracket 20 Into Place Here FAN Backboard Assembly Corner Location Clip ARM Clip Body Install net Insert net into bottom of clip as shown
Top Page Image Contents