Huffy 11S0057 manual Safety Instructions

Page 4

SAFETY INSTRUCTIONS

FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN SERIOUS INJURY,

PROPERTY DAMAGE AND WILL VOID WARRANTY.

Owner must ensure that all players know and follow these rules for safe operation of the system.

To ensure safety, do not attempt to assemble this system without following the instructions carefully. Proper and complete assembly, use and supervision is essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly.

If using a ladder during assembly, use extreme caution.

Check base regularly for leakage. Slow leaks could cause the system to tip over unexpectedly

Seat the pole sections properly (if applicable). Failure to do so could allow the pole sections to seperate during play and/or during transport of the system.

Climate, corrosion or misuse could result in system failure.

If technical assistance is required, contact Huffy Sports.

Minimum operational height is 6’6” (1.98m) to the bottom of backboard.

Most injuries are caused by misuse and/or not following instructions.

Use caution when using this unit.

NOTICE TO ASSEMBLERS

ALL Huffy Sports basketball Systems, including those used for DISPLAYS, MUST be assembled and ballasted with sand or water according to instructions. Failure to follow instructions could result in SERIOUS INJURY. It is NOT acceptable to devise a makeshift weight system.

IMPORTANT!

Remove all contents from boxes.

Be sure to check inside pole sections, hardware and additional parts are packed inside.

P/N 211472

05/04

4

Image 4 Contents
Portable Basketball System Système portable Manuel dutilisation Failure to Follow These WAR I GS MAY Safety Instructions Front Back 206273 Bolt, Hex, 1/2-13 X 4.5 Long Hardware Identifier Nuts & Washers Hardware Identifier BoltsHardware Identifier Other Section a Assemble the Poles Pole Identification Mark LabelPole Identification Mark Section B Assemble the Base 1/205/04 05/04 TOP View 05/04 Section C Assemble the Backboard Front of System Place cover Over screw jack Install pole cap Do not Over 05/04 Straight on View Install clips Insert net into bottom of clip as shown Section D Securing the System Height Adjustment Section E Apply Height and Moving LabelSection G Height Adjustment Adjust Height