Huffy 540D manual Section B Securing the System, If Using Sand

Page 15

SECTION B: SECURING THE SYSTEM

1.Place assembled unit to desired location. Fill tank with water (30 gallons/114 liters) or sand (360 lb./163 kg) and snap tank cap (28) in place.

Insert T-strap (27) through slot on back of base as shown. Secure unit to ground by twisting tie down stake (25) into ground and hooking T-strap (27)

onto tie down stake (25).

 

 

 

 

 

 

 

 

 

 

CAUTION!

 

 

ADD TWO GALLONS (7.6

 

 

LITERS) OF NON-TOXIC

 

 

ANTIFREEZE IN SUB-

27

 

FREEZING CLIMATES.

 

 

 

 

 

 

 

 

 

 

 

28

 

 

 

 

 

 

 

 

 

 

NOTE:

 

AN

D

 

 

 

 

 

)

 

IF USING SAND:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

lb

.

)

2 GALLONS OF

S

 

 

0

 

kg

 

 

 

 

 

 

 

 

3

6

 

3

 

ANTI-FREEZE IS

 

(

(

16

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

NOT REQUIRED

 

 

 

 

 

 

 

 

 

 

 

WARNING!

TWO PEOPLE REQUIRED

FOR THIS PROCEDURE.

FAILURE TO FOLLOW THIS

WARNING COULD RESULT

IN SERIOUS INJURY AND/OR

PROPERTY DAMAGE.

27

25

27

15

10/05

ID# 21198805

Image 15
Contents Pool System Safety Instructions Warranty Card Front 10/05 ID# Hardware Identifier Bolts & Nuts AND/OR Section a Assemble the BaseID# 10/05 Tighten Do not Leave Assembly Section B Assemble the Backboard Board Style MAY Vary Clip ARM Clip Body NET Installation Section B Securing the System If Using SandSection C Apply Height and Moving Label Moving System