Huffy 211573011 manual Middle

Page 8

1.

Identify pole sections.

MIDDLE

 

2

1

5"

(13 cm)

TOP

ID Sticker

5"

(13 cm)

3

BOTTOM

ID Sticker

While maintaining alignment, bounce middle pole section (2) into top section (1)

2.using a wood scrap as shown until the top pole no longer moves toward the pole identification sticker on the middle pole.

IMPORTANT!:

 

NOTE:

 

POLE SECTIONS

Align dimple of top pole section (1)

 

SHOULD HAVE A

 

3-1/2" (9 CM)

into trough of middle pole section (2)

MINIMUM OVERLAP.

 

as shown.

 

 

CAUTION!

 

 

 

pole em

ID

 

THE IDENTIFICATION STICKER IS

 

LOCATED 5" FROM THE END OF

 

STICKER

 

 

 

THE POLE. WHEN PROPERLY

 

 

 

TROUGH

 

2

POUNDED TOGETHER, THE POLE

 

SECTIONS SHOULD HAVE A 3-1/2"

5"

 

 

MINIMUM OVERLAP, LEAVING 1-

 

 

1/2" BETWEEN THE OVERLAPPING

 

pole middle

POLE AND THE IDENTIFICATION

 

STICKER.

 

1-1/2"

 

 

 

 

 

DIMPLE

1

 

 

 

 

 

HOLE

 

WOOD SCRAP

 

 

(NOT SUPPLIED)

 

 

 

P/N 21157301 09/04

 

8

 

Image 8
Contents Portable Basketball System 21157301 09/04 Safety Instructions You may have extra parts Hardware Identifier Bolts & Screws Hardware Identifier Nuts & Washers Before YOU Start Middle Dimple Hole 21157301 09/04 09/04 Orientation of Struts TWO People Required Do not Over Carefully reposition entire Assembly as shown 21157301 09/04 FIG. a Keep Hardware Loose Until After is Completed Toward Board Upper Elevator tube Lower Elevator tube Pole 21157301 09/04 09/04 P/N USE EYE Protection Section D Install Front Cover & Handle Feet 3.05m Install net clips Side View