3.Bounce top and middle pole assembly (1 & 2) onto bottom pole section (3) using a wood scrap as shown. Bounce until the top and middle pole assembly no longer moves toward the pole identification mark on the bottom pole.
IMPORTANT!:
Align dimple of middle pole section (2) into trough of bottom pole section (3) as shown.
TROUGH | Bottom pole |
5"
ID
STICKER
Bottom pole
DIMPLE
HOLE
2
NOTE: |
POLE SECTIONS |
SHOULD HAVE A |
MINIMUM OVERLAP. |
CAUTION!
THE IDENTIFICATION STICKER IS LOCATED 5" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A
MINIMUM OVERLAP, LEAVING 1- 1/2" BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.
1
RODS SHOWN ARE
FOR VISUAL
REPRESENTATION
OF ALIGNMENT
AND ARE NOT
SUPPLIED WITH
THE HARDWARE
3
WOOD SCRAP
(NOT SUPPLIED)
9 | 09/04 P/N 21157301 |