A S S E M B LY
M A N U A L
C a b l e a d j u s t m e n t s
FINE TUNING
Loosen jam nut and thread bolt in/out to give the cable proper tension.
Adjustments may need to be made during the first few session of use. Refer to the chart above for the points where adjustments to the cable tension may be made. The maintenance chart below should be followed to ensure that your equipment remains safe to use and continues to operate smoothly.
MAINTENANCE
(To be performed monthly)
CABLES: If plastic casing is cracked or cables are frayed, the cables should be replaced. Check all cable bolts and cable attachments to be sure they are properly attached. Check slack in cables and readjust cable tension if needed.
MOVING PARTS: Tighten bolts as needed. Replace worn bushings. Inspect pull pin knobs to be sure they are screwed on tightly.
ROTATING PARTS: (I.E. Lat bars, curl bars, etc.) Lube every 300 hours.
GUIDE RODS: Wipe clean with a dust free rag. Lube once a month with Super Lube (Teflon lubricant).
DO NOT USE OIL TO LUBRICATE HOIST EQUIPMENT!
Page - 15
HOIST
R
2061 Assembly
FITNESS SYSTEMS