STEP 2 (See Diagram 2)
A.) Insert two Guide Rods (#13) into the holes on the Weight Gliding Base (#7). Secure each Guide Rod with one M10 x ¾” Allen Bolt (#50) and Ø ¾” Washer (#52).
B.) Slide two Ø 2 ½” Rubber Bumpers (#29) onto the two Guide Rods to the bottom. Slide the Sliding Frame (#8) onto the two Guide Rods.
C.) Attach the Weight Gliding Base to the Rear Base Frame (#4). Secure the side hole with one M10 x 4” Carriage Bolt (#41), one Ø ¾” Washer (#52), and one M10 Aircraft Nut (#54), secure the top hole with one M10 x ¾” Allen Bolt (#50) and one Ø ¾” Washer (#52).
D.) Attach the Upper Frame (#6) to Top Beam (#5) and the two Guide Rods.
E.) Secure the Upper Frame to the Top Beam with two M10 x 2 ¾” Carriage Bolts (#42), two Ø ¾” Washers (#52), and two M10 Aircraft Nuts (#54).
F.) Secure the Top Beam to the two Guide Rods with two M10 x ¾” Allen Bolts (#50) and two Ø ¾” Washes (#52).
G.)Securely tighten all Nuts and Bolts installed in Step-1 and Step-2.
8