Assembly Instruction

Tools Required for Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches.

NOTE: It is strongly recommended that two or more people assemble this machine to avoid possible injury.

STEP 1 (See Diagram 1)

A.) Do not tighten the Nuts and Bolts until instructed to do so.

B.) Attach Front Support Frame (#1) to Rear Support Frame (#2). Secure them together with one M10 x 1” Allen Bolt (#34), two Ø ¾” Washers (#45), and one M10 aircraft Nut (#43) on each end.

C.) Attach a Ø ¾” Rubber Spacer (#24) to the lower hole on Rear Support Frame. Attach one Short Horizontal Support to the Spacer. Align the holes. Secure the Short Horizontal Support, Spacer, and Rear Support Frame together with one M8 x 2 5/8” Allen Bolt (#37), one Ø 5/8” Washer (#46), and one M8 Aircraft Nut (#43). Repeat the same procedure to install the Right Long Horizontal Support (#4) to Front Support Frame.

D.) Connect the Short and Long Horizontal Support together with one M6 x ½” Allen Bolt (#33), one Ø ½” Washer (#47), and one M6 Aircraft Nut (#44).

E.) Repeat Procedure C & D to install the other side.

F.) Press down the Short and Long Horizontal Support completely to stabilize the Front and Rear Support Frame.

G.)Securely tighten all Nuts and Bolts installed.